Possible issues caused by this broken part:
- 6890N GC doesn’t work with hydrogen.
- 6890N GC shutdowns with hydrogen inlet.
- 6890N GC Inlet overheats.
- 6890N GC Inlet wrong temperature.
- 6890N GC doesn’t recognise Inlet EPC.
- 6890N GC Inlet EPC not compatible.
- 6890N GC Inlet EPC bad calibration / re-calibrate / calibration not valid.
Possible errors prompted by this broken part:
GC Control Panel:
- Fault 200 – Pneu board FPGA
- Fault 201 – Pneumatics board
- Fault 202 – Hydrogen shutdown
- Fault 229 – F inl temp too hot
- Fault 230 – F inl temp sensor
- Fault 231 – B inl temp too hot
- Fault 232 – B inl temp sensor
- Fault 247/248 – F/B inlet module rev
- Fault 250/251 – F/B det wrong module
- Fault 252/253 – F/B inlet wrong module
- Fault 254 – Aux wrong module
- Fault 257/258 – F/B inlet invalid type
- Fault 265/266 – F/B inlet invalid pid
- Fault 270/271 – F/B inlet bad cksum
- Fault 275/276 – F/B inlet bad fact cal
- Fault 277/278 – F/B inlet i/o failure
